FORUM THREAD

Your best bet would be to run a simple relay. You could tap into the main power wire going to your amp, and run a relay. This then gives you the ability to run a bunch of lights off of your HU, without hardly drawing any power from it. The relay will have 5 prongs, but you will use four. One will connect to your amp power wire, for constant power.

Car Audio Defined By A Chick

This is where it will draw the power to run your relayed electronics. One will connect to your amp ground. One will connect to your HU wire, as a power selected source, and then one will connect to all your electronics that you want run off of the amp power wire, only while the HU remote wire is hot.


  • litouwse vrouwen dating!
  • dating in egypt;
  • relative dating earth science lab.
  • How to Hook Up a Car Amp Inside the House to a Wall Outlet!

The only way the LED strip would pulse with the bass, would be if you had it hooked up to the speaker output of your amp. It may actually work and pulse for a SHORT while, but then it will burn out very quickly, or just not work at all.

How do you connect a subwoofer to an amplifier?

I had some lights in my trunk and I wired them into the constant power From the battery and of course the main ground, then had a switch on that main power. If you've got a car amplifier you'd like to use in your home, there's one major obstacle to overcome: Wall outlets provide volt AC power, but amplifiers require volt DC power.


  • dream of dating a celebrity.
  • How to wire LED Strips to car audio amplifier!.
  • trials of osiris have matchmaking;
  • speed dating dailymotion!

You'll have to do a little extra wiring, but the problem is not insurmountable. Look up the input power specifications for your amplifier, using the manual or the manufacturer's website.

How to Install an Amp Without RCA Jacks

Find the specification for current draw in amperes. Purchase an AC to DC power inverter. Make sure the inverter can produce a volt DC output at the specified amperage rating.

How to hook up 2 amplifiers or more (read description)

Cut a length of gauge red wire, a length of gauge black wire and a length of gauge wire, each long enough to reach from the amplifier to the inverter. Loosen the REM terminal of the amplifier with a screwdriver.